Skip to main content

Posts

Featured

final print GS-2

 This is the last model that I worked upon, I used the previous one and reshaped parts of it keeping the structure similar. I have improved the legs to increase the structural integrity of it making sure the legs did not break when printing. I created a new weapon for this model, making the model look more intricately designed.  For this model I did a similar process that I did to DX-9. However, in the post-processing phase after the print it was more difficult because the barrel of the gun was narrow and small. One of the prints had damage along the side details. I came to find that the legs without the support of the base, that they were flexible and without the support of the base they would have snapped if I had pushed the print any harder. Once attached to the base the whole miniature became steady and I was confident that it could withstand a good fall. 

Latest posts

DX-9 Printed

DX-9 Pre-printing stage

Stretch goals, pose model and weapons

First batch of capstone designs

Sculpting mech silhouette

vr sclupt test

capstone mech design update 5

test sculp of mech design

Capstone

Introduction